JAFFE, INC. / LED VIDEO WALL PLANNER
Build your LED wall.
Know the requirements.
Plan a Jaffe LED video wall using 0.5 × 1 m portrait panels. See dimensions,
pixel maps, data runs, weight, and power requirements instantly.
Read disclaimer.
Aspect ratio
1 × 1
1.0 decimal
16 × 9 reference = 1.78
Surface area9 m²
Total weight495 lb224.5 kg
Average draw2.16 kW120 W / panel
Maximum draw6.48 kW360 W / panel
FINE PITCH2.9 MM
1,034 × 1,034
PIXELS (W × H)
Panel resolution172 × 345 px
Total pixels1.07 MP
Estimated Cat62 runs
STANDARD PITCH3.9 MM
769 × 769
PIXELS (W × H)
Panel resolution128 × 256 px
Total pixels0.59 MP
Estimated Cat61 run
i
Planning estimate. Cat6 runs assume up to 650,000 pixels per controller output. Final data topology, receiving-card limits, redundancy, electrical circuits, and local code should be confirmed with your LED processor and licensed electrician.
Calculator disclaimer
This calculator is provided for general planning and informational purposes only. Results are estimates based on user inputs and stated assumptions; they are not a quotation, final system design, engineering analysis, electrical or structural advice, or a guarantee of equipment performance. Actual panel dimensions, pixel pitch and resolution, weight, power consumption, processor capacity, data distribution, rigging requirements, wind loading, and site conditions vary by manufacturer, configuration, and venue. Before purchasing, renting, installing, or operating equipment, confirm all specifications and requirements with Jaffe, Inc., the equipment manufacturer, venue personnel, a licensed electrician, a qualified rigger or structural engineer, and applicable authorities. Do not use these estimates for life-safety or code-compliance decisions. To the fullest extent permitted by law, Jaffe, Inc. disclaims warranties and liability for loss, injury, or damage arising from use of or reliance on this calculator.